After you make the purchase of a golf simulator, it is important to ensure that your investment lasts. You will receive the appropriate recommendations from the manufacturer. Follow the instructions as they direct. There are many differences between simulators on the market. Simulators are all different, and there is a lot to be aware of when it comes to the proper care.
You can control the dust
Make sure players only use clean clubs Players who allow their clubs to get even slightly dirty will find all the dirt on your simulator. Sensors and computers don’t tolerate dirt or dust. Your system can become a major problem in commercial environments, where dust is especially common. To control dust, I keep a few showroom clubs available to my players. I wipe them down once per month with a damp rag. To remove as much dirt and grime as possible, I ask my players to wipe their clubs down after every game. You can see dirt on the sims even if the club is clean.
Same goes for the balls. Only house or newly purchased balls are allowed. A ball with a few scratches on it could cause friction burns to the screen. It can also damage the screen. It is important to watch out for cracks or breaks in the balls while they are being played on a simulator.
It is important to remove as much dirt (described above) prior to players setting foot on the simulator. Once a week, I’d dust the computer and vacuum around the areas where players hit the ball. This is a must-do task if your center offers commercial golf.
The manufacturer has specific instructions for cleaning your projector. Clearing out debris from the lens can extend the lifespan of your projector bulbs, which are very costly to replace. The bulb is not covered by most projector manufacturers. You can potentially save thousands or even hundreds of dollars by performing preventative maintenance on your projector.
Keep your Sensor Area clean!
Every golf simulator uses some kind of sensor technology. To ensure good results, the sensors should be kept clean. Although each manufacturer may have specific instructions on how to clean sensors, a good tip is to remove all debris. Sometimes, tiny bits of turf can break apart and block the sensor. You should ensure that nothing in your camera’s view is blocking the camera’s path if you use a camera-based system. A camera-based simulator can misread even a tiny pebble. It is important to vacuum frequently and clean all sensors.
Monitor Maintenance
On most simulators, friction burns are possible. The screen will be impacted by the golf ball and leave a mark. By keeping your screen clean, you can reduce the chances of getting these marks. Ask your manufacturer about cleaning the screen. To remove dirt and dust, many screens can simply be wiped down using a damp cloth. You should contact the manufacturer first before you use water on your screen. Some screens can be permanently damaged by water. You will be amazed at how much dirt and dust has accumulated on your screen if it’s been awhile since your last cleaning.
You can extend the useful life of your simulator by following these easy tips.